Filter
Top Products
Model TGR51 WOW
Setting the clock
Left rear
Oven temperature
control knob
control
Right rear
control knob
Oven light
switch ,
Left front
control knob
&face’
burner indicators
R&ht front
control knob
00
01
Control knobs must be pushed in, then
turned to the LITE position. The clicking
sound is the ignition sparking.
To stop the clicking sound after the burner
lights, turn the control knob back to a
desired setting. The control knob can be set
anywhere between HI and OFF.
Surface burner indicators
The solid dot in the surface burner indicator
shows which surface burner is turned on by
that knob.
Until you get used to the settings, use
the following as a guide. For best results,
start cooking at the high settings; then turn
the control knob down to continue cooking.
Use LITE to light the burner. After the
burner lights, turn control back to a desired
setting to stop the clicking of the ignition.
Use HI to start foods cooking; to bring
liquids to a boil.
Use a medium setting to continue
cooking or to fry chicken or pancakes; for
gravy, puddings and icing; to cook large
amounts of vegetables.
Use a low setting to keep food warm
until ready to serve.
NOTE: Do not cook with the control in the
LITE position.
Using the surface burners
In case of a prolonged power failure
Surface burners can be manually lighted.
Hold a lit match near a burner and slowly
turn the control knob on until the burner
lights. After the burner lights, turn the
control knob to the desired setting.
Burn, Fire and Explosion Hazard
l
Burner flame should not extend
beyond the edge of the cooking
utensil. The flame can burn you
and cause poor cooking results.
l
Be sure all control knobs are
turned to OFF when you are not
cooking. Someone could be
burned or a fire could start if a
burner is accidentally left ON.
9 If the flame should go out while
cooking, or if there is a strong gas
odor, turn the burners OFF. Wait
five minutes for the gas odor to
disappear, before relighting
burner. If gas odor is still present,
see safety note on page 2. Failure
to follow these precautions could
result in explosion or fire.
l
Do not attempt to light the oven
burner during a power failure.
Personal injury could result.
Push in and turn the Minute Timer Knob
to set the Clock.
1. Push in Minute Timer Knob and turn
clockwise until clock shows the right
time of day.
2.
Let the Minute Timer Knob pop out.
Turn clockwise until Minute Timer hand
points to OFF. The clock setting will
change if you push in the knob when
turning.
Using the Minute Timer
The Minute Timer does not start or stop the
oven. It works like a kitchen timer. Set it in
minutes up to an hour. You will hear a
buzzer when the set time is up.
Do not push in the knob when setting
the Minute Timer.
1. Without pushing it in, turn the Minute
Timer Knob until the timer hand passes
the setting you want.
2. Without pushing in, turn the knob back
to the setting you want.
When the time is up, a buzzer will
sound. To stop the buzzer, turn the
Minute Timer hand to OFF.
NOTE: Pushing in and turning the Minute
Timer Knob changes the clock setting.
Page
4