Filter
Top Products
control console
console, allowing
panel(s)
to rest on
bottom of door.
Push in
along
6
n
Snap one end of retainer into
channel as shown. Push inward
while sliding thumb along full
length of retainer.
To change
access colour
panel
(For models so equipped)
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may cause serious injury.
1
n
Push up
with thumbs on
each end of
access panel
top trim to
unsnap trim.
Remove top trim and set it aside.
2
n
Carefully
slide colour
access panel
upwards and
remove. Do Not
remove
spacer.
3
n
With
desired colour
facing out,
bow access
panel and
insert it into
-/
access panel frame. Slide panel
down into groove along bottom of
access panel frame.
4
H Line up
edges of top
trim with sides
of access
panel frame.
Tilt back of trim down and slide
into place. Snap front of trim down
to cover top edge of access
panel.
Parts that must
be custom made
Maxlmum custom door panel
weight Is 4 pound (1.8 kg).
Dishwasher door panel and access
panel (if model is so equipped)
can be customized to match
wood cabinets. A standard, l/4”*
wood panel can be used as is for
customizing the door and access
panels. It is recommended that a
cabinetmaker cut the customized
panel pieces because of the
precise dimensions needed.
l
Cut wood panels so that wood
grain matches direction of grain
in cabinets.
l
File or sand edges of wood
panels.
l
Dishwasher is subject to some
humidity. Apply moisture-resistant
sealer to both sides and edges of
wood panels.
* 7132” (0.56 cm) actual thickness.
Custom
door and access
panels
The custom door panel must not
weigh more than 4 pounds
(1.8 kg).
Cut door panel accurately for a
snug fit between door side frames.
Note: Custom door panel fits
between, Not inside frame.
7/32” (0.56 cm) thickness
Page 10