Filter
Top Products
Custom panel dimensions
Note: This panel is narrower than
access panel.
File or sand edges of wood panel to
avoid slivers.
door panel
side view
top edge 7132”
(0.56 cm)
edge
door panel
front view
L23” (58.4 cm)&
access panel
- 23-5/16” (59.2 cm)
-7
Routing custom panels
clear access
when door
is
7132”
top
view
(0.56 cm) thick
(O.&l cm)
min.
Custom door panel more than
7/X2” (0.56 cm) thick: Route top
and bottom to 7/32” (0.56 cm)
thickness.
Custom access panel more than
7/32” (0.56 cm) thick: Route all four
sides to 7/32” (0.56 cm) thickness.
Custom panels less than 7/X!”
(0.56 cm) thick: Install spacers
behind panels.
wood panels in
door and access
panel
1
n
Cut wood door and access
panels using specified dimensions,
Make sure wood grain direction
matches cabinet wood grain.
2
n
File or sand edges of wood
panels to avoid slivers.
Dlshwasher Is subject to some
humldlty. Cover both sides and
ed
8
es of wood panels wlth
mo sture-reslstant sealer.
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may
cause
serious
injury.
3
n
Insert
finger under
one end of
retainer and
bull towards
iou in a peeling
action. Set
retainer aside.
4
n
Lift door
panel(s) at outer
edges. Use one
po~~~obpw
panel(s). Remove
panel(s) and
spacer. Save
panel(s) and
spacer for future use.
All edges routed to 7132” (0.56 cm)
thickness.
Note: This panel is wider than the door
panel.
Page 11