Filter
Top Products
ins
be
sid
panel fits betwe&
5
not inside, door frame
n
Insert top of wood door
panel between sides of door frame
about 3” (7.5 cm) below console.
Rotate wood door panel down
against dishwasher door. Slide top
edge of wood door panel under
bottom edge of console. Press
lower portion of wood door panel
in place between sides of door
frame, allowing wood door panel
to rest on channel at bottom
of door.
Push in
along length
of retainer.
6
n
Snap one end of retainer into
channel as shown. Push inward
while sliding thumb along full
length of retainer.
7
n
0Der
Check door for proper
.ation. Door should close easilv
without slamming and open with ’
its own weight. If necessary, close
door and adjust both door springs
by moving spring ends to different
holes in base.
8
n
Push
up with
thumbs
on each
end of
access
unsnap trim. Remove top trim
and set it aside.
9.
Carefully slide
colour access
panel and
spacer upwards
and remove,
Save colour access panel and
spacer for future use.
10
n
Insert wood access panel
into access panel frame. Slide
panel down into groove along
bottom of access panel frame. It
may be necessary to remove the
two screws securing top of access
panel to dishwasher frame and tilt
access panel forward to install
some wood panels,
11
n
Line
up edges of
top trim with
sides of access
Tiltbackof$m w
panel frame
down and slide into place. Snap
front of trim down to cover top
edge of wood access panel.
If the
dishwasher is
not operating
properly.. .
Check these points:
l
Is the door closed tightly and
latched securely? -
l
Has the cvcle been set correctly
to start the dishwasher?
l
Is the water supply turned on?
l
Has the electrical power been
connected?
l
Has the circuit breaker been
tripped or the house fuse blown?
l
Has electrical power been
interrupted?
Note: If the motor is stopped
because of overload, it will
automatically reset itself within a
few minutes. If after checking these
points the dishwasher still does not
run or complete a cycle, call for
service.
If you need
assistance...
Call your dealer or authorized
repair service.
When you call, you will need the
dishwasher model number and
serial number. Both numbers can
be found on the model/serial
rating plate behind the dishwasher
door on the front frame,
Part No. 3369689
01996
Benton Harbor, Michigan 49022
Printed in U.S.A.