Filter
Top Products
11
• Spring adjustment pins should be in the same holes
on both the left and right sides.
Move dishwasher into cabinet opening
1. Using two or more people, stand the dishwasher up.
2. Grasp the sides of the dishwasher at the edges of the
door panel.
3. Move dishwasher close to cabinet opening. Do not
push on the front of the panel or on the console—they
may dent.
4. If dishwasher has a power supply cord, insert power
supply cord into hole cut into cabinet.
If using direct wire, check that it is on the right front
side of opening.
5. Check that water line is on the left side of opening and
drain hose is near the center of the hole in the cabinet.
6. Slowly move dishwasher completely into cabinet
opening so that the front corners of the dishwasher
door are flush with the cabinet doors. Do not kink or
pinch copper tubing, drain hose, power supply cord or
direct wire between dishwasher and cabinet.
Helpful Tip: Once the dishwasher is in position, you
may have to support the front of the dishwasher by
raising, lowering or shimming front feet.
7. Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket —the blanket
reduces the sound level.
Level the dishwasher
1. Align front of dishwasher door panel with cabinet
doors. You may need to adjust alignment to be even
with your cabinets.
Helpful Tip: Prop up one side of frame to hold
dishwasher up off floor when adjusting front legs.
With some installations, it may be easier to adjust the
front leg using the 6” adjustable wrench.
2. Check that leveling legs are firmly against the floor.
3. Close and latch the door, and place level against the
front panel. Check that dishwasher is plumb. If needed,
adjust leveling leg or add shims until dishwasher is
plumb.
4. Repeat for other side of dishwasher.
NOTE: Shims must be securely attached to floor to prevent
their movement when the dishwasher is operated.
5. Place level against top front opening of tub. Check that
dishwasher is level from side to side. If dishwasher is
not level, adjust front legs up or down until dishwasher
is level.
Make Electrical Connection
Check “Electrical requirements” section.
You need to:
• have the correct electrical supply and recommended
grounding method.
If you are:
• direct wiring, use Option 1
• using a power supply cord, use Option 2
Option 1, Direct wire method
1. Route direct wire so that it does not touch dishwasher
motor or lower part of dishwasher tub.
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.