Filter
Top Products
4
Plan Your Installation
FIG. 1
PLAN YOUR INSTALLATION
It is recommended to read through the entire manual
before beginning your installation. Follow all steps exactly.
Reading this manual will also help you get all the benefits
from your system.
Your Reverse Osmosis Drinking Water System can be
installed under a sink or in a remote location. Typical
remote sites are a laundry room or utility room. Review the
location options below and determine where you are going
to install your system.
NOTE: For best system performance, the feed water to
the system should be softened or less than 10 grains
per gallon hard.
UNDER THE SINK LOCATION
The Reverse Osmosis Filter Assembly and storage tank
are normally installed in a kitchen or bathroom sink cabi-
net. See Fig. 2.
A suitable drain point is needed for reject water from the
Reverse Osmosis filter.
REMOTE LOCATION
You can also locate the Reverse Osmosis Filter Assembly
and storage tank in a remote location away from the
Reverse Osmosis Faucet. You will need a nearby water
source and drain point.
See Fig. 3.
CHECK SPACE REQUIREMENTS
Check size and position of items for proper installation into
location chosen.
TOOLS NEEDED
Review the tools needed list. See Fig. 1. Gather needed
tools before proceeding with the installation. Read and fol-
low the instructions provided with any tools listed here.
Questions? Visit www.ecodyne.org or call Toll Free 1-866-986-3223
TOOLS NEEDED
Adjustable wrench
Tape MeasurePhillips Screwdriver
Flathead Screwdriver
Drill & Drill bits, if required.
Large Adjustable Jaw Pliers or Pipe Wrench