Filter
Top Products
HEAT DRY
AIR DRY
The AIR DRY signal light
will be ON when AIR DRY
is selected. The AIR DRY
Option helps save en-
ergy, but the dishes take
longer to dry (overnight] and some water spot-
ting may result. Some items (such as plastics)
may need towel drying. For best results, use a
liquid rinse aid such as Jet-Dry’” in the rinse aid
dispenser.
When HI-TEMP is selected,
the water for the main
wash and final rinse is
heated to 145°F (63°C).
While the water is heat-
ing, the WATER HEATING signal light will be ON.
POTS & PANS has the HI-TEMP option preset. HI-
TEMP cannot be selected with RINSE & HOLD.
NOTE: The WATER HEATING signal light will
flash at the end of the cycle if the water did
not heat to 14s”F (63°C). (See page 17.)
DELAY Pad
Biil
The DELAY Pad
. -
allows you to
-* .-
D 1
delay the start of
-. .-
a cycle for 2, 4
or 6 hours after
loading the dishwasher. For example, use DELAY
to run the dishwasher during off-peak hours of
electrical use.
1. Press the DELAY pad once to display the last
cycle and options selection.
2. Quickly press the pad again to select a 2
hour delay. The 2 HOURS signal lightwill come
on.
3. Pressing the DELAY Pad repeatedly will select
(in order] 4 hours, 6 hours, no delay, then 2
hours, etc. If no delay is selected, all delay
signal lights will be off.
4. After 2 hours, the selected signal light will turn
off. If 4 hours or 6 hours was chosen, the signal
light for the next shorter delay time will turn on
and continue to count down. This continues
until the delay time ends and the dishwasher
starts.
l
You may press START at any time during the
delay if you want the dishwasher to start
immediately.
l
Press the CANCEL pad to cancel the delay
and clear the delay signal light.
l
You may add items to the load at any time
during the delay. Close the door firmly to
latch it.
CANCEL Pad
I
The CANCEL pad allows
you to cancel a cycle, to
clear the signal lights or
to make a new selection.
I
If the dishwasher is wash-
ing, it will go into a 2 minute drain automatically
Adding a dish after starting
before shutting off. Pressing CANCEL again stops
the drain. If the dishwasher had not been started
or is not washing, it will clear the display. Press-
ing CANCEL again will start a 2 minute drain, if
needed.
1. Lift up on the door latch to stop the cycle.
Don’t open the door until the spray arms stop
spinning.
10
2. Open the door and add the dish.
3. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that
can come from the vent when restarting the
cycle.
4. Press door firmly to latch it. The dishwasher
will automatically start where it stopped.