Filter
Top Products
Control pad lock-out feature
This feature lets you lock-out the function of the
To cancel the lock-out feature:
control pads (except to CANCEL a cycle that is
running or to pause during a cycle in progress).
b
\
E!Yuim
E!m
1. Press and hold the CYCLE pad until the CLEAN
signal light turns on and stays on.
1. Press and hold the CYCLE pad until the CLEAN
signal light flashes.
2. Release the pad.
m
3. The CLEAN signal light will turn off to show that
the control pads are locked-out.
2. Release the pad.
m
3. The CLEAN signal light will turn off to show that
the control pads are no longer locked out.
The beeping sound
Each time a control pad is pressed, a single
“beep” sound is made. A double beep means
one of the extra features was selected or the
wrong control pad was used.
To turn off the beep:
To turn the beep back on:
1. Press and hold the DELAY pad until the CLEAN
signal light turns on and stays on.
2. Release the pad.
1. Press and hold the DELAY pad until the CLEAN
signal light flashes.
2. Release the pad.
3. The CLEAN signal light will turn off to show that
the beep has been turned on.
NOTE: All extra feature selections are can-
celled by a power failure.
3. The CLEAN signal light will turn off to show that
the beep is turned off.
12