Filter
Top Products
WATER HEATING signal light
The WATER HEATING sig-
HEATING signal light will go off automatically
nal light comes on auto-
when the preset heating time is up.
matically during the
HEAVY NORMAL and LOW
NOTE: The water will stop heating once the
ENERGY Cycles to show
preset time is up. If you want to make sure the
that water is being heated. The heating time is
water gets heated to l45”F (WC), use the HI-
preset for each cycle, and heats the water a few
TEMP Option (see page 10).
degrees to improve washability. The WATER
Selecting an extra feature
Four of the control pads serve two purposes. Besides the functions already listed, they control these
extra features:
r PAD 1 OPTIONS PAD 1 CYC
STAR1 ~~~~
Begins CYCLE
PAUSE.
Cancels CLEAN
signal light when
door is opened.
-LE PAD
Locks out
control pads.
CONTROL PAD
EXTRA FEATURE
DELAY PAD
Turns “beep”
ON/OFF.
These features are described below.
CYCLE PAUSE
A cycle can be stopped at any time for up to 10
minutes.
1. To pause during a cycle, press the START pad.
Any signal lights that are on will flash until the
cycle restarts after 10 minutes.
2. The cycle can be started sooner by pressing
the START pad again.
CLEAN signal
light
To again have the signal light stay on when the
door is opened:
other control pad is pressed.
As an option, you can have the CLEAN light
turn off the first time you open the door after a
cycle is finished:
1. Press and hold the OPTIONS pad until the
CLEAN signal light turns on.
2. Release the pad.
1. Press and hold the OPTIONS pad until the
CLEAN signal light starts flashing.
2. Release the pad.