Filter
Top Products
PROBLEM
CAUSED BY
SOLUTION
Dishes not Water 6 not Water temperature should be at least 140°F [6O”C). Set
washing clean hot enough
water heater thermostat to a higher setting. Run water at
sink until hot before starting and/or use HI-TEMP WASH
Option
Improper loading
Make sure dishes and glassware are loaded so spray
reaches all surfaces and items drain properly. Do not ov-
erload. Do not nest items.
Make sure large items do not block spray from reaching
detergent dispensers.
Spray arm or arms not
Check spray arms to make sure they turn freely after load-
rotating freely
ing. Be sure a utensil has not prevented their turning.
Not enough detergent Use more dishwasher detergent. Use detergent with high-
or improper
est available phosphorus content...especially with hard
detergent
water.
“0ld”detergent.
Use only fresh dishwasher detergent. Store tightly closed
container, in cool, dry place. Discard old detergent. Do not
fill dispensers until ready to start dishwasher.
Water pressure may If water pressure is low, do not use water for other purposes
be low, dishwasher is while dishwasher is running (to assure correct fills].
not fillinq properlv
Cloudy flim on
loo much detergent Check for rarnbow hue on glasses. A rainbow hue is the
glassware,
in soft water frrst sign of etching [corrosion of glass). Reduce the amount
etching -
of dishwasher detergent. Use a detergent with a lower
permanent
phosphorus content.
corrosion
Inadequate rinsing
If water pressure is low do not use water for other purposes
while dishwasher is running [to assure correct water fills).
Make sure dishes and glassware are loaded properly to
assure adequate rinsing and draining. Do not overload.
Dishes L
interior of
dlshwasher
yellow or
brown
Iron or manganese in Temporary remedy:
water
1 Set empty dishwasher for a “one wash”cycle.
2. Start dishwasher and unlatch door to stop It when it has
filled for the wash part of the cycle.
3. Add % to l/2 cup (120 to 240 mL) of citric acid crystals
(usually available in drugstores).
4. Close and latch door to complete cycle.
Permanent solution: Install an iron or manganese filter to
home water supply
Rust spots on
stainless steel
-OR-
Dark spots on
flatware -
stainless steel,
silver plate, or
sterling
Allowing salty or
acidic foods such as
mayonnaise. vinegar,
fruit juices, salad
dressings, milk
products to remain on
flatware.
Undissolved
detergent coming in
contact with flatware
Rinse flatware that is to stand for several hours before
washing (use Rinse & Hold) Clean stained items with silver
polish and re-wash. Do not put stainless steel and silver
flatware In the same silverware basket compartment.
Direct contact between these metals can cause perma-
nent damage to the silver.
Remove spots with silver polish. Avoid spilling concentrated
detergent on wet flatware.
Bronze tarnish
Silverplate is worn off
Remove tarnish with silver polish. Have silver replated
on silverplate Exposed base metal
to kes on a bronzed
hue.
Water iett in
bottom of
dishwasher
Dishwasher cycle not Allow dishwasher to complete cycle.
completed
Clogged drain air
Some plumbing codes require use of a drain air gap be-
gap
tween an undercounter dishwasher and the drain system of
the house. The air gap is usually located above the sink or
on the top of the counter near the dishwasher to prevent the
possibility of water backing up from the drain into the dish-
washer due to a plugged drain. The drain air gap is NOT a
part of the dishwasher and is NOT covered by the dish-
washer warranty. The drain air gap should be kept clean to
ensure proper draining of the dishwasher.
16