Filter
Top Products
4
WOLF PRO VENTILATION HOOD LINERS
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
INSTALLATION CONSIDERATIONS
IMPORTANT NOTE:
Wolf Pro ventilation hood
liners are recommended for use with all Wolf
c
ooking appliances and are available to accom-
modate 36" (914), 42" (1067), 48" (1219), 54"
(1372) and 60" (1524) wide hoods.
Proper installation is the responsibility
o
f the installer. Product failure due to
improper installation is not covered
under the Wolf Warranty. Refer to the Wolf
Pro Ventilation Hoods Use & Care
Information for warranty details, or visit
the Contact/Help section of our website,
wolfappliance.com.
Make sure you have the tools and materials
necessary for proper installation.
Any required service must be performed by
a Wolf authorized service center. Wolf is not
responsible for service required to correct a
faulty installation.
IMPORTANT NOTE:
Wolf Pro ventilation
hood liners are shipped without the blower
assembly. Wolf internal, in-line and remote
blower assemblies are available, refer to
page 14. Use only a Wolf blower with the Pro
hood liner
IMPORTANT NOTE:
Wolf recommends that
the Pro ventilation hood liner be installed
30" (762) to 36" (914) above the countertop.
ELECTRICAL REQUIREMENTS
Wolf Pro ventilation hood liners require a
separate, grounded 110/120 V AC, 60 Hz power
supply. The service should have its own 15
amp circuit breaker. Locate the electrical
supply within the shaded area shown in the
Installation Specifications illustration on
the following page.
You must follow all National Electrical Code
regulations. In addition, be aware of local
codes and or
dinances when installing your
service.
INSTALLATION REQUIREMENTS
LIST OF MATERIALS
T
he following is a list of materials shipped
with the Wolf Pro ventilation hood liner.
Stainless steel hood liner
T
ransition with backdraft damper (attached
inside hood liner—needs to be removed)
Filters (installed in hood liner)
Installation package (taped to filters)
includes:
(8) #10 x 2" (51) Phillips head wood screws
(8) #10 washers
(4) hollow wall anchors
Installation Instructions
Use & Care Information and product
registration card