Filter
Top Products
9
Dimensions in parentheses are in
millimeters unless otherwise specified.
INSTALLATION INSTRUCTIONS
HOOD LINER PREPARATION
If you are installing an in-line or remote
blower, drill a
7
/8" (22) hole through the
w
ood framing for the conduit. Refer to the
in-line and remote blower information on
pages 12–13 and follow installation instruc-
t
ions provided with the blower.
I
MPORTANT NOTE:
D
o not run wiring for the
remote blower through the ductwork.
INSTALL THE HOOD LINER
IMPORTANT NOTE:
If a backsplash is to be
used, it should be installed before the hood
l
iner is mounted.
P
osition the hood liner in the desired location
on the wall. Install the #10 x 2" (59) screws
through the mounting holes on the back plate.
V
erify that the screws engage the wall studs or
framing. If not, wall anchors must be used.
IMPORTANT NOTE:
If additional support is
required for the hood liner, drill supplementary
mounting holes in the back plate and use these
holes to attach the hood liner assembly to the
wall framing.
Due to the weight of the hood liner, be
sure to have adequate manpower for
installation.