Filter
Top Products
Pro Wall Hood Installation 16
24" and 27" Deep Wall Hoods
REATTACH BACK PLATE
Attach the transition to the back plate using the four
shipping screws provided in the hardware mounting kit.
Reinstall the shipping screws removed previously from the
top and back of the back plate. Seal with duct tape to
ensure a tight seal from the transition to the back plate.
If additional support is required, drill supplementary
mounting holes in the back plate and use these holes to
attach the hood assembly to the wall framing.
HOOD INSTALLATION
IMPORTANT NOTE:
If a backsplash is to be used, it should
be installed prior to mounting the wall hood. Refer to
installation instructions provided with the backsplash.
Align the mounting holes in the back plate of the hood
assembly with the retaining brackets on the wood
mounting support. Refer to the illustration below for
location of the mounting holes, one on each side of the
back plate.
Position the hood and install the #10 x 1
1
/2" (38) screws
and washers provided through the mounting holes on the
back plate. Verify that the screws engage the mounting
support. Attach the transition to existing ductwork with
sheet metal screws and seal with duct tape. Refer to the
illustration below.
4
7
/16
"
(113)
2
1
/2
"
(64)
MOUNTING
HOLE
Location of mounting holes. Hood installation.