Filter
Top Products
8
WOLF FRYER MODULE USE & CARE
FRYER MODULE OPERATION
BEFORE USING FOR THE FIRST TIME
C
lean your fryer module thoroughly with hot
water and a mild detergent. Rinse and dry with
a soft cloth. This removes any residual oil and
g
rease left on the surface from the manufac-
turing process.
Refer to Care Recommendations on page 14.
Apply a stainless steel polish to protect the
finish and add luster.
During the initial period of use, you may smell
a light burning odor or see light smoke. Both
these conditions are normal with a new fryer
module.
MODES OF OPERATION
LOCK MODE
I
n
L
ock mode
,
all touch pad operations on
the control panel are disabled and the heating
element is deenergized. A steady glowing light
i
n the “
k
ey
”
touch pad indicates that the unit is
locked. Refer to the illustration below for
location of the “
key
” touch pad.
To lock the control panel, touch and hold
the “
key
” symbol for 3 seconds. The unit
will beep three times and the light in the
“
key
” touch pad will illuminate. The control
unit is now in
Lock mode
.
To unlock the control panel, touch and hold
the “
key
” symbol for 3 seconds. The unit
will beep twice and the light in the “
key
”
touch pad will go out. The control unit is
now in
Idle mode
.
IMPORTANT NOTE:
When the unit is powered
up for the first time or if there has been a
power outage, the fryer module will default to
Lock mode
.
IDLE MODE
After unlocking the control panel as described
in Lock Mode, the unit enters the
Idle mode
of
operation. The valid touch pad operations are
OFF ON
,
LOCK
, ”
+
”, ”
–
” or
CLEAR
.
Oil must be added to the fryer basin
before turning the unit on. Serious injury
or damage to the fryer module may
result when pouring oil into a heated
fryer basin.
Do not use abrasive cleaners; they will
permanently scratch the surface.
T
emperatur
e
LED display
Lock ”key”
touch pad
Power indicator
bar graph
T
emperatur
e
adjustment
OFF ON
touch pad
T
imer LED
display
CLEAR
touch pad
Touch control panel