Filter
Top Products
ZM 24ST GB
50
1. Remove any promotion label from the door.
2. This oven can be used as a free standing oven or
built-in, into a kitchen cabinet using kit number
BF246, which is ordered separately. To install the
oven in a kitchen cabinet follow the instructions
supplied with the building-in kit.
The oven should be installed on a flat, level surface.
The surface must be strong enough to safely bear
the weight (18 kg) of the oven, and the contents.
To avoid the possibility of causing vibration or
noise the oven must be in a stable position.
3. Keep the oven away from heat and water. Exposure
to heat and water can lower oven efficiency and
lead to malfunctioning, so be sure to install the
oven away from heat and water sources.
4.
If using the appliance as a free-standing appliance
do not block air vents on the top and the sides of
the cabinet and also do not place any articles on
the top of the oven. A gap all around the oven is
necessary : 140 mm above the oven and any
objects, 50 mm on the sides and 100 mm behind
the oven. If air vents are blocked during operation
the oven may overheat, and this may lead to mal-
functioning. Hot air escapes from the vents, so be
sure not to obstruct them or let curtains come be-
tween the oven and the rear wall.
5. Place the oven as far away from radios and TVs as
possible. This oven does conform to EEC require-
ments of radio interference suppression, but some
interference may occur if it is placed too close to a
radio or TV, so keep them as far apart as possible.
Electrical connections
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
Connecting to the mains
The oven is delivered with the power cord and a plug
for 240 V, 50Hz, earthed socket outlet.
Earth protection minimizes the risks should a short-
circuit occur. Check to ensure the voltage of the oven
matches the supply.
N.B. If the oven is connected to the socket via an
extension cord, make sure the cord is earthed.
This appliance must not be used on a non-earth
protected power supply. Contact an electrician
if you are uncertain regarding electricial
connection of the oven or provision of earth
protection of the supply.
This appliance must be earthed. If this
appliance is fitted with a non-rewirable plug
for which your socket is unsuitable, the plug
should be cut off and the appropriate plug
fitted. If it is necessary to change the fuse in
a nonrewirable plug, the fuse cover must be
refitted. If the fuse cover is lost or damaged,
the plug must not be used until a replacement
is obtained.
!
!
For the installer