Filter
Top Products
28
If something goes wrong
SYMPTOM
■ The oven does not come on
■ The oven light does not come on
■ It takes too long to finish the dishes, or they are
cooked too fast.
■ Steam and condensation settle on the food and the
oven cavity.
■ The timer does not work
■ The oven fan is noisy
SOLUTION
◆ Press the OVEN ON button, then select a cooking
function.
◆ Check the oven is wired in properly, and the
socket switch or the switch from the mains supply to
the oven are ON.
◆ Select a function with the oven function control
knob
◆ Check the light bulb, and replace it if necessary
(see "Replacing the Oven Light")
◆ The temperature may need adjusting
◆ Refer to the contents of this booklet, especially to
the chapter “Using the Oven”.
◆ Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed. See page 10
◆ Check the instructions for the timer.
◆ Check the grease filter is correctly fitted.
◆ Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
SELF CHECK FUNCTION
The programmer also carries out a self check, in
order to verify that it is working correctly. If a
problem is identified, the spanner symbol
will
be displayed. In the event of a breakdown, a
NUMBER will appear.
If numbers 001 or 002 appear, it means that the meat
probe is at fault and needs to be replaced.
If the symbol
appears when you plug in the
meat probe, ensure the interior of the oven does not
exceed the pre-set temperature of the meat probe.
If a higher number appears, please contact your
nearest Zanussi Service Force Centre.
If the oven is not working correctly, please carry out the following checks, before contacting your local Zanussi
Service Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
When you contact them, they will need the following
information:
1. Your name, address and post code.
2. Your telephone number
3. Clear and concise details of the fault or, if shown on
the programmer display, the fault code.
4. The model and the serial number (which can be
found on the rating plate)
5. Date of purchase
Please note that it will be necessary to provide proof
of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.