Filter
Top Products
10
CHILD
SAFETY OFF ON
PROBE
TEMP.
COOK
TIME
STOP
TIME
MINUTE
MINDER
Automatic switch off
Should you forget to switch the oven off after a
programme, or if the "ON" button is pressed
accidentally, the oven will switch off automatically.
In fact, in the case of manual functioning, the
programmer will switch the oven off automatically if
no other button is activated after a certain time. This
time varies according to the temperature setting of
the oven, and ranges from a minimum of 2 hours for
temperatures above 230°C, up to 8 hours for those
below 120°C.
At the end of automatic cooking, the oven will switch
off after a period of time, this depends on the tempe-
rature selected.
The time varies between 2 hours for temperatures
above 230°C, up 8 hours for those below 120°C.
Child Safety
To avoid children altering a selected programme or
temeperature, the Child Safety facility can be
operated.
Press the "Child Safety" button and the "Oven On"
button at the same time and keep them pressed for
approximately 5 seconds.
The padlock symbol
will be displayed.
It is now only possible to select a function while
simultaneously pressing the "Child safety"
button.
To cancel the Child Safety Feature, press the "Oven
On" button. Then press button the "Child Safety"
button and the "Oven OFF" button at the same time
and keep them pressed for approximately 5 seconds.
The padlock symbol will disappear from the display.
Call for technical assistance
The programmer display carries out a self check, in
order to verify that it is working correctly. If a
problem is identified the spanner symbol will be
displayed, and in the event of a breakdown a
NUMBER will appear. If NUMBERS 001 or 002
appear it means that the meat probe is at fault and
needs to be replaced. If a higher number appears,
please contact your nearest Zanussi Service Force
Centre quoting the number of Fault Code.
NOTE:
Generally after about 8 seconds from pressing a
function button the programmer will allow the
selected function to operate. Should another button
be pressed during the operation of a function, the
display will show momentarily details of the function
in progress. For the new command to be accepted it
will be necessary to press the other button again.