Filter
Top Products
25
Before installing the cooker, it is necessary to assemble
the supplied feet. You can find them in the oven cavity.
l Carefully lean the cooker on its back (Fig. 1),
paying attention not to cause any damage.
l Adjust the feet height. A height indicator is
printed on the last page of this Instruction book
(Fig. 2). Lean the foot on the page and make
the foot match with the indicator, then unscrew
the bottom part of the foot, until you obtain
the required height. Repeat the same
operation with the other feet.
l Screw the feet into the relevant holes indicated
in figure 1.
l Lift the cooker in vertical position.
l Ensure that the cooker is level. If necessary,
adjust by turning the bottom part of the feet,
until the appliance is completely stable. (Fig.
3). A spirit level should be placed on a cake
tray on one of the shelves to confirm that the
appliance is correctly levelled.
Fig. 1
FO 2284
Fig. 2
Fig. 3
830
840
850
860
870
880
890
900
910
F
Feet Assembly
FO 2283
A stainless steel splash back is supplied with the
appliance. This is meant to be fitted on the rear edge of
the cooker's hob. The splash back is inserted into the
polystyrene upper part of the package.
1. Carefully clean the hob top.
2. A foam rubber gasket is supplied in the
instruction book envelope.
3. After cleaning the hob from possible grease
and film residuals left, fix the gasket on the
rear part of the hob, paying attention not to
close the fan slots (Fig. 4).
4. Take the splash back out of the envelope
and remove the protective film.
5. Insert the splash back into the proper hinges
in the rear part of the hob (Fig. 5).
6. Fix the splash back with the supplied
screws (Fig. 6).
Splash back Assembly
Fig. 4
FO 2367
Fig. 5
FO 2286
FO 2285
Fig. 6
FO 2287
F