Filter
Top Products
- 18 -
Installation
Preparing the outer door
Screw the guide rods and hinges on the door into place
using the predrilled holes.
Mounting plate
Before installing the dishwasher and adjusting the door
onto the cupboard, put the mounting plate into its correct
position on the shelf.
1. Place the mounting plate in the middle of the
cupboard. Mark the holes for screws and the
holes for dismounting the outer door. There is a
middle mark on the plate to help you.
2. Drill 4 holes with a diameter of 7 mm. The door
can be disconnected if necessary, through hole
1 (two holes).
3. Then screw the plate into place from under-
neath using the 2 screws provided, with the
washers between.
4. Snap the hinges into the brackets on the
mounting plate.
The outer door should be supported under-
neath in order to prevent the hinges from
breaking off.
5. Adjust the door to surrounding doors using
screws A, B and C.
1
1
A
B
C
C
2x
4x