Filter
Top Products
- 19 -
Installation
Fitting the outer door
1. Unscrew the screws on the mounting plate. Lift
the plate off together with the door.
2. Lay the machine down on its back. Check that
none of the hoses are trapped. Insert the guide
rods into the plastic door guides.
3. Slot the tabs on the mounting plate into the
holes on the front plinth of the machine and
screw the mounting plate into place using the
2 screws provided.
Fitting protective and cap strips
In order to fill the gap between the cupboard and the dish-
washer and to protect the cupboard above from any steam
that comes out of the washer, a self-adhesive protective
strip is attached along the upper edge of the cupboard
and two gap strips are attached along the edge of the
cupboard.
1. Clean all surfaces where the strips are to be
attached to ensure better adhesion.
2. Attach the protective strip along the upper edge
of the cupboard. If it is too long, it can easily be
cut to the right length.
3. Attach the two gap strips along each side of the
cupboard, level with the front edge of the sides.
Tab