Filter
Top Products
- 9 -
Starting the programme
1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
(See the basket and loading).
3. Put the correct amount of detergent into the
detergent dispenser and close the dispenser lid.
4. Press in the On/Off button. All programme
indicator lamps are lit.
5. Press in the required programme button (see
programme chart). All other programme
indicator lamps goes out.
6. Close the door.
7. Check the filters to see if they need to be
cleaned when the dishwasher has finished
the programme.
Stopping the programme temporarily
1. Open the door. The programme stops.
2. The programme indicator lamp is lit.
3. Close the door and the programme continues
after about 6 seconds.
Open the door carefully when the dishwasher is
running, since hot steam may escape which
could damage surrounding cabinetry and could
cause an injury.
Cancelling the programme
1. Open the door.
2. Press and hold in the combination buttons,
the machine goes to starting position and all
programme indicator lamps are lit.
3. Release the buttons. The programme is now
cancelled and a new programme can be
selected.
If you switch the dishwasher off, the selected
programme is not cancelled, it is only interrupted.
When you start the dishwasher again, the pro-
gramme will continue.
Pause function
With the pause function the programme can be temporarily
interrupted for a short period of time.
1. Open the door and press the On/Off button. The
programme stops.
2. All lamps goes out.
3. When you want the programme to continue again,
press the On/Off button once more and close
the door. The programme continues.
The programme should not be paused for any
longer than necessary, because the water inside
the dishwasher has cooled down and must be
heated again which increases the power
consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is
completed, you can cancel it by opening the door. The
drying phase is now cancelled.
Switching the dishwasher off
Switch the dishwasher off when the end of programme
buzzer sounds (approx. 15 seconds) or the end of pro-
gramme lamp is lit.
1. Open the door and press the On/Off button.
Be careful if you open the door immediately
after the programme is finished, since hot steam
may escape.
This dishwasher has a new feature called
”IMPULSE WASHING”. This washing system
varies both the revolutions of the pump and the
water pressure for more intensive cleaning of the
dishes during the programme. That is why different
sections of the programme cycle do not sounds
the same.
Using the appliance