Filter
Top Products
FITTING INTO THE SPACE
BETWEEN CABINETS
Ensure the cooker is in front of the cabinet.
See Fig. 13.
Take out all oven furniture before installation
to reduce the weight you need to lift.
To place the cooker into the space between
cabinetry follow the procedure below:
N.B. Two people will be required to carry out
the lifting procedure.
Each person should squat either side of the
cooker.
Tilt the cooker so that your hands can
support the underside of the cooker.
Raise the appliance to the correct height.
Rest the rear underside of the cooker on the
mounting brackets while your hands support
the front.
The cooker can be pushed fully into the
space. Take care to avoid fouling the mains
lead.
Ensure the cooker is central and level.
When the cooker is fully housed, screw the
stability screws (supplied with the cooker) into
the underside of the worksurface in the
positions indicated (see Fig. 14), taking care
not to distort the trim. It is advisable to turn
each screw alternately to avoid damaging the
trim.
Place the top trim flush with the edge of the
worksurface, with the cork spacers upover
(see Fig.15) and screw into position using the
screws supplied with the cooker.
Replace the plinth board.
Switch on the cooker and refer the user to the
operating instructions.
55
INSTALLATION INSTRUCTIONS
Fig.13
IMPORTANT: Ensure that the oven is
switched off at the wall before any
further work is carried out.
Fig.14
Fig.15