Filter
Top Products
5
Thermostat Controls
A thermostat control is located in the top panels inside
the freezer and refrigerator compartments, which
controls the temperature inside the freezer and refrig-
erator respectively.
The Freezer Temperature Control
The thermostat control located inside the freezer
regulates the temperature within the freezer
compartment. A change in the control setting in the
freezer compartment could affect the temperature in
the refrigerator compartment under certain
circumstances.
Off - Switches off cooling to the appliance
Coldest - Maximum coldness
Cold - Minimum coldness
An intermediate position is usually the most suitable,
although the temperature will be affected by:
• Room temperature
• How often the door is opened
• How much food is stored
• Position of the appliance
In determining the correct temperature control setting
all these factors have to be considered and some
experimentation may be necessary.
When altering the temperature settings, allow 24
hours for the temperature to stabilise before making
further changes.
Important
Turning the freezer control to “OFF” will shut down
cooling in BOTH the refrigerator and the freezer
compartments.
The Refrigerator Temperature Control
The thermostat control located inside the fridge
regulates the temperature within the fridge compart-
ment, by regulating the cold air flow.
A setting midway between coldest and cold is usually
the most suitable, although some experimentation may
be necessary to obtain the correct temperature.
Coldest - Maximum coldness
Cold - Minimum coldness
The ice maker is located behind the baffle in the top
of the freezer.
Once the freezer temperature is cold ice making can
be started.
To start ice making, lift the flap to allow access to the
wire signal arm and lower it to the ‘ON’ position.
To stop ice making raise the wire signal arm to the
“OFF” position.
Ice Maker
Wire Signal Arm
Lift Up
Lower
Water Dispenser
A water tank is located at the back of the refrigerator
compartment and holds approximately 1.5 ltrs (48fl
oz) of water.
To fill the water tank after installation:
Ensure the selector is positioned to “Water”. Draw
and discard one glass of water. This action will fill the
tank, it will take approximately 1 ½ minutes. Continue
to draw and discard 7 more glasses of water to ensure
that all plumbing connections have been rinsed.
The tank automatically refills as water is dispensed.
To ensure fresh tasting water, we recommend you use
the water dispenser daily.