Filter
Top Products
9
Ice Dispenser
Clean the the dispenser and storage bin periodically.
1. Remove storage bin. Stop ice production (raise
signal arm).
2. Empty and clean the storage bin with a cloth and
mild solution of washing up liquid and water. DO
NOT submerge the bin in water or use abrasive
cleaners.
3. Remove ice chips, clean the shelf and ice chute.
4. Replace storage bin.
5. Begin ice production again (lower wire signal
arm).
Important
The Storage bin should be removed if:
• A power failure causes the ice in the machine to
melt and then refreeze, as they may cause the ice
making mechanism to jam when the power is
resumed.
• The ice maker is not used frequently.
Do not put fingers up the ice chute, there may
be sharp edges.
DO NOT rotate the spiral rod, when replacing
the ice bin. To realign the spiral rod, rotate it
in 90
o
turn until the ice bin fits into place with
the driver mechanism.
Maintenance and Cleaning
Before any maintenance or cleaning work is
carried out DISCONNECT the appliance from
the ELECTRICITY supply.
Internal Cleaning
Clean the inside and accessories with warm water and
bicarbonate of soda (5ml to 0.5 litre of water). Rinse
and dry thoroughly.
Regularly check the door seals and wipe clean to
ensure they are clean and free from debris.
Do not use detergents, abrasive powders,
highly perfumed cleaning products, wax
polishes or cleaning products containing
bleach or alcohol.
Defrosting
Your appliance is frost free, which means there is no
need to manually defrost your appliance as this will be
carried out automatically.
Changing a Light Bulb
Ensure the appliance has been disconnected
from the mains supply before changing a light
bulb. Turning the thermostat control to the
“OFF” position does not disconnect the
appliance.
It is adviseable to wear gloves or use a cloth
when changing a light bulb.
Refrigerator Compartment
Unscrew the old bulb and replace with a 220-240 Volt,
40W bulb with an E27 screw thread.
Freezer Compartment
Remove the hexagonal nut retaining the bulb cover.
Unscrew the old bulb and replace with a 220-240 Volt,
40W bulb with an E27 screw thread.
Ice & Water Dispenser
Unscrew the old bulb and replace with a 220-240 Volt,
7W bulb with an E14 screw thread.
Wire Signal Arm