Zanussi ZKT 863 LX Range User Manual


 
8
Before using for the first time
Initial Cleaning
Wipe the ceramic glass surface with a damp cloth.
1 Important: Do not use any caustic, abrasive
cleaners! The surface could be damaged.
Operating the hob
Touch control sensor panels
To operate the touch control sensor panels, touch
the desired panel with the tip of your pointed finger
until the relevant displays illuminate or go out, or until
the desired function is carried out.
3 Ensure that you are only touching one sensor
panel when operating the appliance. If you fin-
ger is too flat on the panel, the sensor panel
below may be actuated as well.
Switching on the appliance
The entire appliance is switched on using the ”On/
Off” sensor panel .
Touch the “On/Off” sensor panel for approx. two
seconds.
The digital displays will show ¾.
3 After the “On/Off” sensor panel has been ac-
tuated to switch on your appliance, a cooking
setting must be selected for a cooking zone
within approx. 10 seconds, or a time must be
set using the timer (egg timer function). If not,
the appliance will switch itself off again for rea-
sons related to safety.
Switching off the appliance
To completely switch off the appliance, actuate the
“On/Off” sensor panel .
Touch the “On/Off” sensor panel for approx. one
second.
3 After switching off a single cooking zone or the
entire cooking surface, the existing residual
warmth will be displayed in the digital displays
of the corresponding cooking zones in the
form of h (for “hot”).