Electrolux
45
Oven Cavity
The enamelled base of the oven cavity is best
cleaned whilst the oven is still warm.
Wipe the oven over with a soft cloth soaked in
warm soapy water after each use. From time to time it
will be necessary to do a more thorough cleaning, using
a proprietary oven cleaner.
Cleaning the Oven Door
Before cleaning the oven door, we recommend you
to remove it from the oven.
Proceed as follows:
1. open the oven door completely;
2. find the hinges linking the door to the oven (Fig. 1);
3. unlock and turn the small levers located on the two
hinges (Fig. 2);
4. handle the door by its left- and right-hand sides, then
slowly turn it towards the oven until it is half-closed
(Fig. 3);
5. gently pull the oven door off its site (Fig. 3);
6. place it on a steady plan;
Clean the oven door glass with warm soapy water
and a softh cloth only. Never use harsh abrasives. Once
the cleaning is carried out, refit the oven door, following
the procedure in reverse.
Stainless steel or aluminium appliances:
We recommend that the oven door is only cleaned
using a wet sponge and dried after cleaning with a soft
cloth.
Never use steel wool, acids or abrasive products
as they can damage the oven surface. Clean the oven
control panel following the same precautions.
DO NOT clean the oven door while the
glass panels are warm. If this precaution
is not observed the glass panel may
shatter.
If the door glass panel becomes chipped or has deep
scratches, the glass will be weakened and must be
replaced to prevent the possibility of the panel shattering.
Contact your local Service Centre who will be pleased
to advise further.
Fig. 1
Fig. 2
Fig. 3