Filter
Top Products
Removal of glass shelf blockers from
the product
The glass shelf blockers are used to fix the shelves
into position during product transport. These blockers
will not be necessary for the further operation of the
product.
Open the refrigerator door as wide as possible.
1 Slide the blocker tabs to the front of the shelf.
2 Lift the back of the shelf from its nest and then pull
it towards yourself by tilting its front
upwards/downwards.
3 Remove the blocker tabs.
Door reversal
Should the location demand it, the door-opening direction
can be refitted from right-handed to left-handed.
Appliances are supplied right-handed.
Following operations are to be done on the basis of figures
and explanations:
To perform the operations listed below it is
recommended to ask another person for help who safely
can hold the doors while performing the operations.
Disconnect the appliance from the electricity supply.
Open the doors and dismount the double door hinge (a,
b) by removing the screws (2 pieces) (c). (fig.2)
Take off the double door hinge (a, b, c) by gradually
removing it from the cabinet, slightly tilting both doors.
Do not forget to remove the plastic spacer (b) under the
hinge. (fig.2)
Take off the refrigerator door by pulling it slightly
downwards.
Take of the freezer door by pulling it slightly upwards.
Remove the plug on the upper side of the refrigerator
door and put it to the other side.
Remove the plug on the upper side of the freezer door
and put it to the other side.
Unscrew the top door hinge pin (d) of the refrigerator
then screw it back on the other side. (fig.1)
Remove the plugs (u) at the bottom of the appliance.
(fig.3)
Remove the lower hinge (e) by removing its screws (s)
and mount it on the other side. (fig.3)
Unmount the lower hinge pin (f) and its washer (h) and
mount them into the other hole of the lower hinge. (fig.3)
Replace the plugs (u) on the other side.
Remove the covering pins (3 pieces) (n, k) of the double
door holder on the left side and put them to the other
side. (fig.2)
Fit the pin of the double door hinge (m) into the left drill
hole of the freezer door. (fig.2)
Fit the freezer door to the lower door hinge pin (f). (fig.3)
fig. 1.
fig. 2.
18