Filter
Top Products
22
Using 3in1 detergents
These products are detergents with a combined
cleaning, rinsing and salt function.
When the 3in1 function is activated,
– the addition of special salt and rinse aid from the
respective dispenser is prevented.
– If the salt and rinse aid dispensers are empty, this
is not indicated.
– The dishwashing cycles can be up to 30 minutes
longer.
3 If you want to use 3in1 detergents, check
whether these detergents are suitable for your
water hardness. (Follow the manufacturer’s in-
structions.)
If you want to use 3in1 products
1.Press the ON/OFF button.
2.Go to the 3 IN 1 option.
3.Set the value to ON (see section “Adjusting an op-
tion/setting” symbol lights up in the symbol
line.
Before the start of the dishwashing cycle put 3in1
detergent in the detergent dispenser.
3 As the rinse aid inflow is automatically
switched off when the 3in1 function is activat-
ed, it may come about because of the different
quality standards in the 3in1 detergent, that
the dishes do not dry sufficiently.
If this happens, proceed as follows (see sec-
tion “Adding rinse aid”):
• Fill up the dispenser (if this is empty) with rinse aid.
• Set rinse aid dosage to “2” mechanically.
• Activate rinse aid inflow.
If you do not want to use 3in1 products
any more
If you want to stop using 3in1 products, please do
the following:
• Deactivate the 3in1 function.
• Fill up the dispensers for salt and rinse aid again.
• Switch the water softener to the highest setting
and perform up to three normal cycles without
loading any dishes.
• Then set the water softener to the water hardness
in your area.
If you want to use 4in1 products
When using "4 in 1" detergents that integrate also
anti- glass corrosion agent into "3 in 1" formula,
please follow the same indication as given for "3 in
1" detergents.