Filter
Top Products
26
Switching Off the dish-
washer
Switch off the dishwasher if the messages PRO-
GRAMME END and PLEASE SWITCH OFF are being
displayed alternately.
With some dishwashing cycles, the drying fan con-
tinues to run even after the end of the cycle.
If the acoustic signal has been enabled, a continuous
tone will sound for 15 seconds at the end of the dish-
washing cycle.
If the dishwasher is not switched off, then the acous-
tic signal is repeated after 3 minutes and after 6 min-
utes.
1.Press the ON/OFF button. Display goes out.
2.Turn off the water tap.
1 Carefully open the door. Hot steam may es-
cape.
• Hot dishes are sensitive to knocks. Therefore leave
the dishes to cool for about 15 minutes before re-
moving them. You also get a better drying result.
• Dishes dry more quickly if you open the door for a
moment after the cycle has ended and then leave it
slightly open.
Removing the Dishes
3 It is normal for the inner door and the dispens-
ers to be damp.
• Empty the lower basket first, then the upper bas-
ket. This way you avoid dripping water from the
upper basket onto dishes in the lower basket.
• The dishwasher's interior light will always be on
when the door of the appliance is open. Therefore,
in order to save energy, you should always close
the door of the dishwasher after having loaded or
removed dishes.
Button lock
Using the KEY LOCK option, you can prevent unin-
tentional use of your dishwasher – perhaps by chil-
dren. You can temporarily cancel the button lock
(and then operate your dishwasher) or switch off the
button lock again.
Switching the button lock on
1.Switch on the appliance.
2.Go to KEY LOCK option; see section “Adjusting an
option/setting”.
3.Switch on KEY LOCK option.
In the display the symbol flashes. While the sym-
bol flashes, you can operate the dishwasher.
15 seconds after the last button activation, the
symbol is permanently lit. This locks the buttons.
The button lock remains active even when the dish-
washer is switched off and then switched on again.
Cancelling the button lock temporarily
1.Press and hold any button (except the ON/OFF
button) for five secoinds.
Symbol begins to flash, button lock is temporarily
cancelled, you can operate the dishwasher.
If you do not press any buttons for 15 seconds, the
button lock automatically switches itself on
(symbol is then lit permanently).
Switching the button lock off
1.Cancel the button lock temporarily.
In the display the symbol flashes.
2.Go to the KEY LOCK option; see section “Adjust-
ing an option/setting”.
3.Switch off the button lock.
Symbol goes out, you can operate your dish-
washer again normally.