8. Keep machine clean for better and safer performance. Follow the instructions for
lubricating and changing accessories. Inspect compressors cord periodically and if
damaged have it repaired by a qualified technician. Inspect all hoses for leak prior to
use. The handle must be kept clean, dry and free from oil and grease at all times.
9. Be sure that keys and adjusting wrenches are removed from the unit or work surface
before using.
10. Make sure the air pressure adjustment is set at “0 PSI” and the shut off valve is in the off
position when not in use and before attaching the air compressor.
11. Do not operate the unit when tired or under the influence of alcohol or drugs.
12. Before using check for alignment and binding of moving parts, any broken parts or
mounting fixtures and any other conditions that may affect proper operation. Do not use
the unit if any switch does not turn on or off properly.
13. When servicing only use parts and accessories intended for use with this unit.
14. Drain water trapped in the air pressure adjuster periodically.
15. Do not allow sand blaster to be pressurized while unattended or not in use.
16. Make sure all equipment is rated to the appropriate capacity. Make sure that regulator is
set no higher than 125PSI.
17. Periodically check the abrasive medium delivery equipment. Valves, hoses and nozzles
that carry the abrasive medium after it leaves the pressure tank are subjected to the
sandblasting action and will wear out more quickly than other components.
18. Release the air pressure in the tank before opening. Open the shut off valve to release
pressure. Make sure pressure gauge reads “0 PSI” before opening the tank. Do not
attempt any repairs to the sandblaster until the gauge reads”0 PSI”.
19. Maintain correct air pressure whenever working. Do not allow pressure to exceed
125PSI. If the safety valve does not release excess air pressure, stop all work and open
the shut off valve to release pressure in the tank.
WARNING:
The warnings and cautions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors that cannot be built into this product but must be
supplied by the operator.
