A SERVICE OF

logo

Sand Metering Valve and Sanding Gun Assembly (Refer to Fig 2):
1. Attach the sand metering valve (#26) to the side hole of the intake manifold (#12).
Attach one of the elbow connectors(#13) and one of the hose adaptor (#23) to either
remaining hole of the intake manifold (#12)
2. Attach the other side of the sand metering valve (#26) to the bottom of the tank.
3. Slide the hose clamp (#22) over either side of the sand hose (#21). Do not tighten yet.
4. Slide the two ends of the sand hose (#21) onto the sanding gun (#24) respectively.
Tighten the hose clamps (#22) very securely.