Air Pressure Adjuster and Safety Valve Assembly (Refer to Fig 3):
Use PTFE tape on all air fitting threads.
1. Attach the connector (#8) to one of the side inlets of the air pressure adjuster (#9).
Attach the intake manifold (#12) to the other side of the nipple connector (#11). Make
sure the pressure gauge on the air pressure adjuster and the front inlet of the intake
manifold face the same direction, as in figure 3.
2. Attach the joint pipe (#10) to the front intake of the intake manifold (#12). Attach the
other side of the joint pipe to the threaded port on the top of the tank (#15).
3. Attach the safety valve (#5) onto the threaded port on top of the tank (#15).
4. Screw the tank filler cap (#4) onto the filler opening with o-ring (#3) in between to ensure
an airtight seal.
5. Attach the elbow connector (#13) to the remaining side port of the intake manifold (#12).
Make sure the other end of the elbow connector points to the other elbow connector in
the bottom assembly (#13 from figure 2).
6. Attach the two ends of the air hose (#20) to the two elbow connectors (#13) in the top
assembly and the bottom assembly respectively.
