A SERVICE OF

logo

ASSEMBLY:
NOTE: Use Teflon pipe tape on all threaded joints. Make sure all joints are securely
tightened.
Legs, Wheels and Handle Bar Assembly (Refer to Fig 1):
1. Attach both the left leg (#7) and the right leg (#17) to the tank (#15) using the four
screws & nuts. The bottom section of the two legs must point outward respectively and
the holes in the bottom of the legs must be parallel to each other to accommodate the
axle (#25).
2. Attach one of the wheels (#16) to the axle (#25) using one of the cotter pins (#14).
3. Slide the axle through the holes in the bottom of the two legs, using four cotter pins (#14)
to fix the position of the axle.
4. Attach the other wheel (#16) to the axle (#25) using the remaining cotter pin (#14).
5. Slide the handle bar (#6) onto the left leg (#7) and the right leg (#17) and secure it with
two self-tapping screws.
6. Slide the two end caps (#18) over the ends of the legs (# 7 & # 17)