Electrolux
EFS - Dishwashing Systems Platform
Electrolux Professional
DOC. NO. 5956.677.00 P. 12 / 30
The table given below indicates the delay between transit of the rack on the autorinse lever and stopping of
the rinse phase.
E.g. in a WT44 working at high speed (200 racks/h) the rinse pump keeps operating for 3 seconds after the
last rack has released the autorinse lever.
A3.1.2 RINSE MODULE (rin)
The RINSE MODULE family parameters are selected and edited by using the buttons in the same way as that
described for the GENERIC FUNCTION family.
The RINSE MODULE family contains the parameters that identify the rinse module characteristics
The RINSE MODULE / rin family parameters are described below:
A3.1.3 WASH MODULE (tub)
The WASH MODULE family parameters are selected and edited by using the buttons in the same way as that
described for the GENERIC FUNCTION family.
The WASH MODULE family contains the parameters that identify the wash module characteristics
The WASH MODULE / tub family parameters are described below:
A3.1.4 PREWASH MODULE (PrE)
Available only on WT66 with prewash.
The PREWASH MODULE family parameters are selected and edited by using the buttons in the same way as
that described for the GENERIC FUNCTION family.
Capacity speed nr. 1 (racks/
hour)
Delay speed nr. 1 (sec) Capacity speed nr. 2 (racks/
hour)
Delay speed nr. 2 (sec)
WT44 100 6 200 3
WT66 100 6 200 3
Parame-
ter name
Display
visualiza-
tion
Family
Nr.
Parameter
Nr.
Parameter description Unit of
measure
Min Max Factory set-
ting [for WT44]
Boiler
temper.
bot
2 4 Boiler temperature set point. °C / °F 10/50 99/
211
86/187
Parame-
ter name
Display
visualiza-
tion
Family
Nr.
Parameter
Nr.
Parameter description Unit of
measure
Min Max Factory set-
ting [for WT44]
Tank
temper.
tut
3 45 Tank temperature set point. °C / °F 5/42 90/
194
75/167
Autom.
drain del.
Atd
3 10 Number of racks passing between two
automatic water changes. If this
parameter is set at zero the function is
disabled.
Racks 0 600 200
FAM
tub
