Connecting the Printer to the Network
(continued)
10Base-T Interface
1 Plug the connector of your
twisted-pair network cable into the
10Base-T port (RJ-45) on the HP
JetDirect print server. The other end
of the cable should be attached to a
twisted-pair hub/concentrator.
2 If you are not connecting other
network cables, go to Step 18.
DIN-8 (LocalTalk) Interface
1 Plug the end of your DIN-8 cable
into the LocalTalk port on the HP
JetDirect print server.
NOTE
If you are using only the LocalTalk port,
HP MIO 1 INITIALIZING will appear
every time you turn on the printer. This
message will automatically disappear after
5 minutes. If the message does not
disappear, there is a problem with the print
server or your network. To stop the
message from appearing during normal
operation, connect a BNC "T" connector
with two 50-ohm terminators to the BNC
connector.
10Base-T Interface Connector
DIN-8 Interface Connection
24 - Getting Started Guide EN
