34003602EN/AB - Page 27
< 3m
2. Installation
8 - Clean the planned location for the
external unit using the cleaning kit provided
(see figure).
9 - Remove the adhesive protection from
under the external unit.
10 - Place the unit as shown.
11 - Press down hard for 10 seconds to fix
the adhesive.
12 - Connect the power supply cord 20 to
the back of the external unit (5V DC).
13 - Connect the one end of the telephone
cable 22 to the "phone" port on the external
unit and the other end to the telephone
outlet. If the wall outlet is not compatible with
the connector on the cable, use an adapter.
14 - Connect the cable 21 to the JBUS /
RS485 terminal block on the card:
- wire T- on terminal T-,
- wire R+ on terminal R+,
- shielding.
(A)
Galaxy view with doors open and protective panels in place
22
22
20
21
