34003602EN/AB - Page 29
2. Installation
PowerServices TelPac external unit (2 inputs + 4 extensions)
Four similar inputs C, D, E, F are available
inside the external unit on terminal block
XM13.
To connect contacts to these four inputs,
proceed as follows:
◗ Remove the cover (partly unscrew the
screws and pivot the cover).
◗ Remove the card from the external unit (3
screws).
◗ Feed the cable through the grommet.
◗ Connect the cable(s) to terminal block
XM13 as shown in the figure opposite.
◗ Replace the card in the external unit and fix
it in place (3 screws).
◗ Replace the cover.
PowerServices TelPac is now ready for the
parameter setting stage required for
Teleservice. Consult the Technical Support
documentation. Lastly, move on to step 2
(see section 2.1 "Procedure").
Extension
C
D
E
F
Settings
JBUS / RS485
PowerServices TelPac
UPS
CD
Phone
A 5V B R+ R- T+ T-
A
B
5V
< 10m
Terminal block
XM13
