A SERVICE OF

logo

400
Check and clear of the faults history
(2) Clearing procedure
POINT
· The faults history can be cleared by setting "1" in Er.CL Faults history clear.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Parameter setting mode
Press to choose the parameter setting mode.
(The parameter number previously read appears.)
3.
Selecting the parameter number
Turn until " " (faults history clear) appears.
Press to read the present set value. " " (initial value) appears.
4.
Faults history clear
Turn to change it to the set value " ". Press to set.
" " and " " flicker alternately after the faults history is cleared.
·By turning , you can read another parameter.
·Press to show the setting again.
·Press twice to show the next parameter.