26
Chapter 5 Reference
5-1 Attaching an Arm (Option)
The stand can be removed and replaced with an arm (or another stand) to be
attached to the monitor. Use an arm or stand of EIZO option.
[Attaching]
1
Lay the LCD monitor on a soft cloth spread over on a stable
surface with the panel surface facing down.
2
Remove the stand. (Prepare a screwdriver.)
Unscrew the two screws (M4 × 10mm) securing the unit and the stand
with the screwdriver.
3
Attach the monitor to the arm or stand.
Secure the stand to the monitor with four screws (M4 × 12mm) using a
screwdriver.
DVI D-SUB
Arm
Fixing screws: M4 × 12mm 4 pcs
5-2 Cleaning
Clean the monitor periodically to keep the monitor clean and extend its life.
Cabinet
Clean the cabinet with a soft cloth dampened with little mild detergent.
LCD Panel
• Clean the LCD panel with a soft cloth such as cotton cloth or lens cleaning
paper.
• Remove persistent stains gently with a cloth dampened with little water, and
then clean the LCD panel again with a dry cloth for better fi nishing.
Attention
• When using another manufacturer’s
arm or stand, confi rm the following in
advance.
• Clearance between the holes of the
arm fi xing screws: 100 mm × 100
mm (VESA compliant)
• Strong enough to support weight of
the monitor unit (except the stand)
and attachments such as cables
• Connect the cables after attaching an
arm.
Chapter 5 Reference
Attention
• Never use any solvents or chemicals,
such as thinner, benzene, wax,
alcohol, and abrasive cleaner, which
may damage the cabinet or LCD
panel.
NOTE
• Optional ScreenCleaner is
recommended for cleaning the panel
surface.
