4. Now you can either:
Type I and press to move the cut up.
You’ll see
Amount of Cut increase
[0-144]: 0___(Dots)
Enter a number form 0-144 for the amount of space to
move the cut and press . For example, 10 moves
the cut .052 inches (there are .0052" per dot). The screen
then shows the Print Option menu.
Type D and press to move the cut down.
You’ll see
Amount of Cut decrease
[0-144]: 0__(Dots)
Enter a number from 0-144 for the amount of space to
move the cut and press . The screen then shows
the Print Option menu.
5. Select another print option, or press to exit to the main
menu.
Adjusting the Print Position
This feature adjusts where the data prints on the supply. It is
only for slight adjustments. For example:
• If the data overlaps the preprint on the supply, enter
steps to move the printing down.
• If the data is too close to the bottom, enter steps to
move the data up.
9400 Series Operator’s Handbook
5-4
