ST-4
USER MANUAL
54
{๎ LNB 2: SATELLITE SETUP.
Using the Standard navigation Mode, select the satellite (satellite name) or the
Transponder Memory Plan (PLAN) to which the LNB2 has to be aligned.
Right to the satellite name or, resp. the Transponder Memory Plan, the reference
transponder for the LNB2 alignment is displayed.
If required, use the Standard Navigation Mode to select a different reference
transponder.
{๎ DISH ALIGNMENT & FINE DISH ALIGNMENT
Once selected the desired satellites, the LCD will display the Noise Margin and
the Quality Test results (FAIL, MARGIN, PASS) for each LNB. Each Noise
Margin value (LNB1 and LNB2) will be also displayed on a level bar with peak
level memory.
Move the antenna dish till you get the maximum Noise Margin value on both
LNB at the same time. The peak level memory of each level bar displays a
vertical bar showing the maximum Noise Margin level reached by the relevant
LNB while pointing.
In some cases it wonโt be possible to maximize the Noise Margin value for both
LNBs, depending on the signal receiving conditions. In this case the antenna
should be set to get the best compromise between the Noise Margin value of the
two LNBs.
Press once and release the MEAS [4] key to quit this function.
18.3 POINTING AND MOVING A MOTORIZED DISH (DiSEqC
MOTOR)
Select the satellite (proceed as described in Chapter 19.1 EXPLORING ALL THE
TRANSPONDERS OF A SATELLITE at page 57) or the transponder included in the
satellite to which the antenna must be aligned (refer to the paragraph 19.2
MANUALLY TUNING THE TRANSPONDER at page 58).
Press once and release the DiSEqC MOTOR
[D] key. The LCD will display:
