55 Setting up the GA-1040 as a PostScript printer
Setting up the GA-1040 in the Chooser
After you install the Adobe PostScript printer driver and PPD file (see “Setting up the
GA-1040 as a PostScript printer” on page 53), you need to set up the GA-1040 in the
Chooser in order to take full advantage of its features. This section describes how to set
up the GA-1040 with the AdobePS printer driver.
TO SET UP THE GA-1040 IN THE CHOOSER
1. Select Chooser from the Apple menu.
Make sure AppleTalk is set to Active.
2. Select the correct AppleTalk Zone, if necessary.
3. Click the AdobePS icon.
The GA-1040 appears in the Select a PostScript Printer list in the form of <server
name>_<device name>_<print connection>. The device name (GA-1040) is the
internal name of your printer.
NOTE: Only the print connections (Direct, Hold, and Print) that have been enabled in
Setup appear in the Chooser.
