I INTRODUCTION
Installation
(continued)
• The Surround Speakers are packed in a separate box inside this container. Unpack the Speakers
carefully and set them up as shown below.
TV rear
3 o) o E
2 3
Connec_on
Connect one end of the
speaker cable to the
terminals on the Surround
Speaker.
2
Connect the other end of the speaker
cable to the "REAR SPEAKER"
terminals* on the TV rear panel.
While depressing the button, insert
the cable. Then, release the button.
*Note:
The REAR SPEAKER terminals can
be used only for the supplied
speakers.
Do not connect any other speakers to
these terminals.
Connect another speaker following
steps 1 and 2 above.
Mounting position
To enjoy the sound of the DSP Surround or Dolby Pro
Logic Surround features, you must mount the speakers
to the left and right, on a shelf or on a wall behind your
normal viewing position. See page 39 for details.
Note;
You can get the best surround performance when you
install the speakers slightly above your viewing position
while watching TV.
CAUTIONS
• If the speakers are mounted on a wall, hang them
from the opening provided on their back panels.
• Care should be taken when choosing speaker
mounting hardware to insure compatibility with the
material of the wall. Do not use mounting hardware
with thin and/or soft wall materials, as the speaker
may fall and cause personal injury or be damaged.
II
L speaker R speaker
6
