Filter
Top Products
English 202391A
5
Check the 3M
TM
Bair Paws
TM
system website to ensure you have the most recent version of this document. www.bairpaws.com reorder #202391A
• Do not allow the power cord to get wet.
• Remove the warming unit from service and contact 3M Patient Warming Technical
Support at 1-800-773-7775 if the warming unit is subjected to a large uid spill (e.g.
I.V. or blood bag).
• is equipment must only be connected to a supply mains with protective earth.
• Connect power plug only to receptacles marked “Hospital Only” or “Hospital Grade”.
5. To reduce the risks associated with cross contamination:
• Do not use the warming unit in an operating room.
• Gowns are intended for single-use only.
6. To reduce the risks associated with re:
• Always follow standard safety protocols when using high intensity heat sources near a
Bair Paws gown.
CAUTION:
1. To reduce the risks associated with impact or property damage:
• Initiate patient warming only after the warming unit is safely placed on a hard surface
or securely mounted.
• Do not use a Bair Paws gown to transfer or move the patient; injury may result.
2. To reduce the risks associated with environmental contamination:
• Follow applicable regulations when disposing of this device or any of its electronic
components.
3. To reduce the risks associated with thermal energy:
• Do not cut the gown, and do not connect the gown to a warming unit if the fabric is
torn or cut; air channels could be damaged.
• Avoid rolling, gathering, bunching or compressing the air-channel insert of the gown as
this can occlude airow and reduce warming of the patient. Extend the insert to its full
length for optimal heat transfer when connected to a warming unit.
4. To reduce the risk associated with impact or tripping:
• Do not use the Bair Paws pediatric gown unless the patient is over 102 cm (40 inches)
tall.
5. To reduce the risks associated with pinching or device damage of the suction wall
mount adapter:
• Only hold the front of the adapter when increasing/decreasing the expander.
• Overtorquing the suction wall mount adapter may cause device damage.