Filter
Top Products
GBC 2064WF-1 Operation Manual
© 2009 General Binding Corporation an ACCO Brands CO. Page 12
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
Lower Tension Idler: (Fig.8A&9A)
The Lower Tension Idler Guides the lower
lamination onto the Bottom Main Roller insuring a
constant amount of wrap on the Bottom Main
Roller.
Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.8B) is used to
adjust the amount of brake that is being applied to
the film or media.
Supply Shaft:
The Supply Shaft (Fig.8C&9A) is used to hold
film to be used, and to apply brake tension.
Core Chuck:
Bi-Directional Core Chucks (Fig.8D) grip the
Medias supply tube. Our patented roller core
chuck will allow the operator the ability to add or
remove film with ease.
Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.10A) is used
to adjust the amount of brake that is being applied
to the film or media.
Cooling Fan Bridge: (Fig.11A)
There are 3 internal Cooling Fans. The fans can
be used to cool down media while it passes
through the Main Rollers and into the Pull Rollers.
Rewind Tubes:
The Rewind Tubes (Fig.11B) are used to rewind
release liners or finished Medias.
Lower Tension Idler: (Fig.8A&9A)
The Lower Tension Idler Guides the lower
lamination onto the Bottom Main Roller insuring a
constant amount of wrap on the Bottom Main
Roller.
Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.8B) is used to
adjust the amount of brake that is being applied to
the film or media.
Supply Shaft:
The Supply Shaft (Fig.8C&9A) is used to hold
film to be used, and to apply brake tension.
Core Chuck:
Bi-Directional Core Chucks (Fig.8D) grip the
Medias supply tube. Our patented roller core
chuck will allow the operator the ability to add or
remove film with ease.
Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.10A) is used
to adjust the amount of brake that is being applied
to the film or media.
Cooling Fan Bridge: (Fig.11A)
There are 3 internal Cooling Fans. The fans can
be used to cool down media while it passes
through the Main Rollers and into the Pull Rollers.
Rewind Tubes:
The Rewind Tubes (Fig.11B) are used to rewind
release liners or finished Medias.