Filter
Top Products
GBC 2064WF-1 Operation Manual
© 2009 General Binding Corporation an ACCO Brands CO. Page 7
PRE-INSTALLATION
Before a 2064WF-1 Laminator can be installed, ensure
the following requirements are met:
1. Are doorways and hallways wide enough for
the laminator to be moved to the installation
site?
2. Is there ample room for the laminator?
• A work area must be established that allows
for operation in both the front and rear of
the laminator and provides space for
efficient material flow.
3. Is the environment appropriate for the
laminator?
• The laminator requires a clean, dust and
vapor free environment to operate properly.
• Avoid locating the laminator near sources
of heat or cold. Avoid locating the
laminator in the direct path of forced,
heated or cooled air.
CAUTION: Air flow can cause uneven
heating / cooling of the rollers and result in
poor output quality.
4. Have you contacted a certified electrician to
wire the receptacle and ensure that adequate
power is being supplied, having the
appropriate capacity, over current protection
and safety lockouts available?
GBC 2064WF-1 WF Requires:
• 220V at 60Hz with 40 amps single phase.
• Nema 6-50 P 50 A 250V Receptacle
This Machine is supplied with a Nema 6-50 male
plug.
INSTALLATION
1. Shipping damage should be brought to the immediate attention of the delivering carrier.
2. With assistance, carefully roll the laminator into position over flat and even surfaces.
3. The laminator should be positioned to allow exiting film to flow freely to the floor or a work table. Accumulation
of laminate immediately behind the laminator as it exits the equipment may cause the film to wrap around the pull
rollers, resulting in a “jammed” condition.
4. Avoid locating the laminator near sources of heat or cold. Avoid locating the laminator in the direct path of forced,
heated or cooled air.
5. Once the laminator has been properly positioned, lock the castors in place. Locking the castors prevent the
machine from rolling during set up, operation or servicing.
6. Connect the attachment plug provided with the laminator to a suitably grounded outlet. Avoid connecting other
equipment to the same branch circuit to which the laminator is connected, as this may result in nuisance tripping
of circuit breakers or blowing fuses.
Note: Machine must be leveled to ensure best performance. Level the machine by lowering both the main and pull rolls.
Lay a level on top of the main and pull rolls. Then, check level from main roll to pull roll on right and left side of
the roll. Finally, check by placing the level diagonally across lower main to lower pull rolls.