Filter
Top Products
Installing and Connecting
36
INSTALLING AND CONNECTING
1
Important: Assembly and connection of the new appliance may only
be performed by an approved installer.
Please observe this instruction, otherwise the warranty will not cover
any damage that may occur.
Installation
Important Information
• The veneer or plastic coverings on kitchen furniture around the
appliance must be bonded with heat resistant adhesive (100 °C). If
plastic coverings or the adhesive are not sufficiently temperature
resistant, then the covering may distort or come loose.
• In respect of fire protection, this appliance corresponds to type Y
(EN 60335-2-6). Only this type of appliance may built into positions
with a high cupboard or wall on one side.
• The separation between the hob and the extractor hood must be at
least as large as that given in the extractor hood installation instruc-
tions.
Appliance Alignment
Underneath the appliance there
are 4 adjustable feet with the aid
of which you can compensate for
small amounts of unevenness in
the floor.
0 1. Remove the utensils drawer
2. Turn the adjustable feet to raise
or lower them until the cooker is
level.
3. Replace the utensils drawer.
3
The adjustable feet are easier to
turn if the cooker is tilted slightly
to take the load off the feet.
+
_
+
_