Filter
Top Products
14
Power
Switching on power
You can switch the front cooking
zone to extra heat for a maximum of
10 minutes .
1. Press the
k
knob.
2. Set the cooking zone to level “9”
by pressing the
l
or
m
button.
3. Press the
P
button.
When Power is switched on, the
Power control lamp will light and
the cooking zone will output 3000
W. Meanwhile the rear right-hand
cooking zone will provide a maxi-
mum 600 W output, corresponding
to level 7. If you attempt to turn the
rear right-hand cooking zone to a
level higher than level 7 while the
front right-hand zone is set to Power,
Power will automatically be turned
off. The front cooking zone will then
continue operation at level 9.
Deactivating Power
1. Press
P
.
Changing from Power to a differ-
ent level
1. Press
P
.
2. Press
1
or
m
until the desired
level shows on the display.
31
Cutting Out
When mounting this unit: Read the
instructions on this page. When
mounting the hob together with
other units: Read the instructions on
the next page.
For mounting the hob you need a
Philips screwdriver and the 4 clamp-
ing fittings supplied with this prod-
uct (see fig.).
Distance to Wall:
Minimum 150 mm to flammable
material. Minimum 50 mm to non-
flamable material.
1. Cut a hole in the table top
according to the measures stated.
See “Technical data”, “built-in
measurement”.
2. Place the unit upside down on a
mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in
the holes in the side of the base
panel (see fig.)
4. Place the unit in the hole and
tighten the clamping fittings to
the table top using a screwdriver.
Clamping fittings
Mounted clamping fittings