Filter
Top Products
OPERATING INSTRUCTIONS
MN-28664 • Rev 2 (06/13) • ASC-4G Gas Convection Oven - Manual Control • 15
a
c
b
e
f
d
NOTE: Under normal operating conditions, the burner will ignite within four
(4) seconds. If the burner does not ignite within fifteen (15) seconds,
usually as a result of insufficient gas flow or air trapped in the gas
line, the ignition system will lockout and must be reset.
1. Press POWER SWITCH A to the ON position.
2. Press FAN SWITCH C to high or low fan speed.
3. Set THERMOSTAT E to the temperature desired.
The LIGHT OFF\OVEN READY indicator light 4 will illuminate and the
oven will begin to heat to the set temperature. When the set temperature is
reached, LIGHT OFF\OVEN READY indicator light 4 will go out.
4. When the oven is preheated, load product into the oven. For best results,
always load the oven from the bottom to the top position and load as
quickly as possible to retain maximum oven compartment heat.
5. Set TIMER F by rotating the knob clockwise. The timer will begin to
count down. When the timer reaches zero, the oven will produce an
audible alert signal that will continue until the timer knob is turned
counterclockwise to the OFF position. Note: The oven will continue to cook
until the thermostat or the power switch is turned to the OFF position.
SHUTDOWN PROCEDURE
1. Rotate THERMOSTAT E to the OFF position.
2. Set the FAN SWITCH C to FULL SPEED.
3. Open the oven doors.
4. Press POWER SWITCH to the COOL DOWN B position. To help protect
the motor, allow the fan to operate until the oven is cool.
5. When the oven is cool, press the POWER SWITCH A to the OFF position.
GAS IGNITION LOCKOUT RESET
1. Rotate THERMOSTAT E to the OFF position.
2. Set the FAN SWITCH C to FULL SPEED to exhaust any residual gas.
3. Wait for a period of five (5) minutes before attempting a restart.
ALLOW A MINIMUM OF 20 MINUTES TO PREHEAT THE OVEN.
NOTE: Turn the main circuit breaker for this appliance OFF if the oven will
not be in operation for an extended period of time.