Alto-Shaam ASF-60E Fryer User Manual


 
Electric Fryer Operation & Care Manual • 35
DELUXE CONTROL OPERATION
To exit the control programming mode at any time, press and hold the LEFT arrow key.
PROGRAMMING THE CONTROL
“Product”
“HoldTime”
Thissub-menuallowstheoperatortoprogramatimeintervaltoliftthebasket(s)and
allow the product to drain before signaling the end of the frying cycle. There is no
“HoldTime” programmed into any of the products shown on the product chart. The
control provides hold time adjustment from “OFF” up to a period of 60 minutes.
Press the right
4arrow key to enter the “HoldTime” sub-menu. Display stops flashing. The
previously set hold time or “OFF” will appear in the display. Press the Up
or
Down arrow keys to change the setting. Whenthecorrect“HoldTime” appears,
press the Right4 arrow key to confirm the setting. If no hold time is required, press
the Down arrow key and scroll until “OFF” appearsinthedisplay.Whenthe
correct setting appears, press the Right4 arrow key to confirm. Display flashes.
Entry into the Product programming mode allows the operator to program all available
product keys. After the final “Product” key has been programmed, the LEFT
arrow key must be pressed to completely exit the control programming mode. The
control will revert to the “OFF” position.
To program control features other than Product, press and hold the “PROGRAM” key
for a period of 5 to 10 seconds from the “OFF” position. Press the Up
or Down arrow keys and scroll to the program function to be set.
Off
1:00
HoldTime
Product